Satellite Dish Installation In Al Barsha , Al Jaddaf, Dubai

Our expert technicians at Al Barsha electronics will assist you at every step while satellite dish installation in Dubai. As prescribed by our expert technicians, you are advised to perform the following steps

Choose the receiver: Buy a multi-output LNB (Low Noise Block converter) so that you can easily add another recorder or tuner later as per your need. The LNB sits on the end of the dish arm and is the device that receives the satellite signal.

Preparing the cable: Run a cable from your chosen receiver to your dish. Ensure to choose satellite-grade cable for optimum picture quality. You will also need a pair of F connectors, which are the plugs on each end of the cable.

Assemble your satellite dish

Follow the instructions provided to assemble your satellite dish. This primarily involves fitting the LNB to the arm, with the connectors facing downwards. Choose the size of the dish depending upon the location where it is to be mounted.

Choose your mount

The mount to be chosen depends upon where you wish to place your dish: The mount must be kept closer to the wall if you don’t want to rotate it Choose a mount that allows you to place the dish further out if you need to rotate it

Mount your satellite dish

• Choose a wall that allows you to fix the dish and also move it from side to side
• Align the brackets vertically, use a hinge, and mount the dish to the bracket.
• Ensure all bolts and screws are secured tightly, preventing the dish from moving in strong winds.

Elevate your dish

Mount the dish on the pole, ensuring the bolts are tight enough that you can move the dish from side to side with a little pressure, but not so loose that the dish moves on its own.

Now, set the elevation by using a compass.

Determine the direction in which you should point your satellite dish. You can count on our experts for satellite dish installation in Dubai.

Connect your dish

After aligning and elevating your satellite dish, you can connect it to the receiver.

Drill or make a hole for the cable. Do this at an angle to prevent water from running into the hole. Now, cut off a short piece of wire, then fit the F connector to the end that leads to the receiver.

Find the satellite

The easiest way to do this is to use a satellite finder, which makes a whistling sound when it receives a signal from the LNB.

Connect the receiver to the socket and use the short cable you made to link from the LNB to the other one.

Switch on the receiver, then adjust the dial on the finder until it reaches 5.

Otherwise, move the dish until you find the strongest signal.

Contact us for service of satellite dish installation

In case, if you’re not picking up any channels, the dish may not be aligned correctly. Our expert technicians at Al Barsha electronics, known for providing you with the best satellite dish installation in Dubai can pay you a home visit at a very reasonable cost or you can pay you a home visit at a very reasonable cost, or you can schedule a virtual meet with them for any further assistance. At Al Barsha electronics, we promise to deliver the best services to our clients serving their faith and interest in us. For satellite dish installation in Dubai, you can count on us.